IBM BladeCenter PN41, Problem Determination And Service Manual, Page: 49 / 88

3. Carefully lay the DPI blade on a flat, static-protective surface.
4. Remove the cover of the DPI blade. See “Removing the DPI blade cover” on
page 30 for more information.
5. Remove the XFP module if one is installed in the DPI blade. See “Removing an
XFP module” on page 32 for more information.
6. Remove the SFP module if one is installed in the DPI blade.
7. Disconnect the control-panel cable from the control-panel connector.
8. Press the bezel-assembly release on both sides and pull the bezel assembly
away from the DPI blade.
9. If you are instructed to return the bezel, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Replacing the bezel assembly
The following illustration shows how to install the bezel assembly.
Control-panel
connector
Bezel-assembly
release (both sides)
Control-panel
cable
Bezel
To install the DPI blade bezel assembly, complete the following steps:
1. Read the safety information that begins on page v and “Installation guidelines”
on page 25.
2. Carefully slide the bezel assembly onto the DPI blade until it clicks into place.
3. Connect the control panel cable to the control panel connector on the system
board.
Chapter 4. Removing and replacing DPI blade components
37