IBM BladeCenter PN41, Problem Determination And Service Manual, Page: 48 / 88

To connect the transceiver module cable, complete the following steps:
1. Remove the protective caps from the ends of the fiber-optic cable.
Protective cap
Fiber-optic
cable
2. Gently slide the fiber-optic cable into the transceiver module until it clicks into
place. (The following illustration shows an XFP module and cable.)
3. Check the LED next to the port connector on the DPI blade bezel. When the
transceiver module is operating correctly, the green link LED is lit.
Removing the bezel assembly
The following illustration shows how to remove the bezel from the DPI blade.
Control-panel
connector
Bezel-assembly
release (both sides)
Control-panel
cable
Bezel
To remove the bezel, complete the following steps:
1. Read the safety information that begins on page v and “Installation guidelines”
on page 25.
2. If the DPI blade is installed in a BladeCenter unit, remove it. See “Removing the
DPI blade from the BladeCenter unit” on page 27 for more information.
36
IBM BladeCenter PN41 Type 3020 Deep Packet Inspection Blade: Problem Determination and Service Guide