Management
module
controls
and
indicators
OK
TX/RX
LINK
Power-on LED
Management
module error LED
Ethernet link
LED
Ethernet activity
LED
IP reset button
Active LED
IP
Management
module
LEDs:
These
LEDs
provide
status
information
about
the
management
module
and
remote
management
connection.
For
additional
information,
see
the
“Light
path
diagnostics”
section
in
the
Hardware
Maintenance
Manual
and
Troubleshooting
Guide
on
the
IBM
BladeCenter
Documentation
CD.
v
Power-on:
When
this
green
LED
is
lit,
the
management
module
has
power.
v
Active:
When
this
green
LED
is
lit,
it
indicates
that
this
management
module
is
actively
controlling
the
BladeCenter
unit.
Note:
Only
one
management
module
actively
controls
the
BladeCenter
unit.
If
there
are
two
management
modules
installed
in
the
BladeCenter
unit,
this
LED
is
lit
on
only
one.
v
Management
module
error:
When
this
amber
LED
is
lit,
it
indicates
that
an
error
has
been
detected
somewhere
on
this
management
module.
When
this
indicator
is
lit,
the
system
error
LED
on
each
of
the
BladeCenter
system
LED
panels
is
also
lit.
v
Ethernet
link:
When
this
green
LED
is
lit,
there
is
an
active
connection
through
the
port
to
the
network.
v
Ethernet
activity:
When
this
green
LED
is
flashing,
it
indicates
that
there
is
activity
through
the
port
over
the
network
link.
Management
module
IP
reset
button:
Do
not
press
this
button
unless
you
intend
to
erase
your
configured
IP
addresses
for
the
management
module
and
lose
connection
with
the
remote
management
station,
the
I/O
modules,
and
the
blade
servers.
If
you
press
this
button,
you
will
need
to
reconfigure
the
management
module
settings
(see
the
information
beginning
with
for
instructions).
Use
a
straightened
paper
clip
to
press
the
recessed
button
in
one
of
the
following
sequences
to
reset
management-module
settings:
v
Press
the
IP
reset
button
for
3
seconds
or
less;
then,
restart
the
management
module
to
reset
the
IP
configuration
of
the
management
module
network
interfaces
(Ethernet
1,
Ethernet
2,
gateway
address,
and
so
forth)
to
the
factory
defaults.
2
BladeCenter
Management
Module:
User’s
Guide
Summary of Contents for BladeCenter Management Module
