IBM BladeCenter HS22V 7871, Problem Determination And Service Manual

Page: 235 / 258

3) Media tray cable (if applicable)
4)
Media tray
b. Replace the following components one at a time, in the order shown,
restarting the blade server each time:
1) Removable-media drive cable (if applicable)
2) Media tray cable (if applicable)
3) Removable-media drive
4) Media tray
7. Check for correct Advanced-Management-Module operation (see the
documentation for your BladeCenter unit).
Note: Some BladeCenter unit types have several management-module
components that might have to be tested or replaced (see the Installation Guide
for your Advanced Management Module for more information).
8.
Replace the Advanced Management Module (see the documentation for your
BladeCenter unit).
If these steps do not solve the problem, it is likely a problem with the blade server.
See “Removable-media drive problems” on page 177 or “Universal Serial Bus
(USB) port problems” on page 180.
Network connection problems
Use this information to diagnose and resolve network connection issues with the
blade server.
To check for network connection problems, complete the following steps until the
problem is solved:
1. Make sure that:
v
The network cables are securely connected to the I/O module.
v
Power configuration of the BladeCenter unit supports the I/O-module
configuration.
v
Installation of the I/O-module type is supported by the BladeCenter unit and
blade server hardware.
v
The I/O modules for the network interface that is being used are installed in
the correct BladeCenter I/O-module bays and are configured and operating
correctly.
v
The settings in the I/O module are correct for the blade server (settings in
the I/O module are specific to each blade server).
2.
Check for correct I/O-module operation; troubleshoot and replace the I/O
module as indicated in the documentation for the I/O module.
3. Check for correct management-module operation (see the documentation for
your BladeCenter unit).
Note: Some BladeCenter unit types have several management-module
components that might have to be tested or replaced (see the Installation Guide
for your Advanced Management Module for more information).
4. Replace the Advanced Management Module (see the documentation for your
BladeCenter unit).
If these steps do not solve the problem, it is likely a problem with the blade server.
See “Network connection problems” on page 169.
Chapter 6. Diagnostics
219