IBM BladeCenter HS21 1885, Problem Determination And Service Manual

Page: 100 / 140

Removing the bezel assembly
To remove the bezel assembly, complete the following steps.
Control-panel
connector
Control-panel
cable
Bezel
Bezel-assembly
release (both sides)
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 75.
2. Open the blade server cover (see “Removing the blade server cover” on page
80 for instructions).
3. If a Memory and I/O Expansion Blade is installed, remove it (see “Removing an
expansion unit” on page 82).
4. Press the bezel-assembly release on each side of the blade server and pull the
bezel assembly away from the blade server approximately 1.2 cm (0.5 inch).
5. Disconnect the control panel cable from the control panel connector.
6. Pull the bezel assembly away from the blade server.
7. Store the bezel assembly in a safe place.
Installing the bezel assembly
To install the bezel assembly, complete the following steps.
Control-panel
connector
Control-panel
cable
Bezel
Bezel-assembly
release (both sides)
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 75.
2. Connect the control-panel cable to the control-panel connector on the system
board.
3. Carefully slide the bezel assembly onto the blade server until it clicks into place.
84
BladeCenter HS21 Types 1885 and 8853: Problem Determination and Service Guide