IBM BladeCenter HS20, Installation And User Manual

Page: 46 / 88

Completing the installation
To complete the installation, complete the following tasks. Instructions for each task
are in the following sections.
1. Reinstall the blade server bezel assembly, if you removed it (see “Installing the
blade server bezel assembly” on page 35 for information on installing the bezel
assembly).
2. Close the blade server cover, unless you installed an optional expansion unit
(see “Closing the blade server cover” on page 35).
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade cover before installing the blade
server.
3. Reinstall the blade server into the BladeCenter unit (see “Installing the blade
server in a BladeCenter unit” on page 36).
4. Turn on the blade server (see “Turning on the blade server” on page 13).
5. For certain options, run the blade server Configuration/Setup Utility program
(see “Updating the blade server configuration” on page 37).
Note: If you have just connected the power cords of the BladeCenter unit to
electrical outlets, you must wait until the power-on LED on the blade
server flashes slowly before pressing the power-control button.
34
BladeCenter HS20 Type 7981: Installation and User’s Guide