IBM BladeCenter Copper Pass-thru, Installation Manual

Page: 37 / 56

Chapter 3. Information LEDs and external ports
This chapter describes the information LEDs (also known as indicators) on the
copper pass-thru module and identifies the copper pass-thru module external
ports.
Front panel
The front panel of the copper pass-thru module has status LEDs, an LED
matrix, and three external copper-interface ports, as shown in the following
illustration. Each interface port supports up to five-channels of bi-directional
communication, which support fourteen external communication channels.
Note: The port-3 E connector is not used.
The copper pass-thru module contains:
v
LEDs that display the status of the copper pass-thru module and its network
connections (see “Information LEDs” on page 25).
1
5
6
10
11
14
1
2
3
LINK OK
! Status LEDs
LED matrix
Port 1
Port 2
Port 3
Figure 5. Copper pass-thru module external ports and LED matrix
© Copyright IBM Corp. 2012
23