IBM B-Series, Maintenance Information

Page: 38 / 648

Figure 10 (Page 2 of 5). ATTENTION LIBRARY Messages
Message
Meaning
FRUs FRU Name or Description Prob-
ability
TAC
Code &
(Duration
in hours)
Page Reference or Instruction
Clear
Picker
Path A
The device detected the presence of a possible blockage in the cartridge path, such as in the magazine or in the
priority cell.
1. Check the position of all cartridges to ensure they are properly positioned in the magazine and in the priority
cell. A cartridge that extends too far into the magazine in the import position or a damaged cartridge can
cause this error.
2. Check for a binding or sticking cartridge door.
3. Remove the magazine and look for any obvious obstructions.
4. Try another magazine in the library.
5. Before replacing FRUs below, ensure that the global and priority cell sensors are operating correctly. See
Figure 130 on page PANEL-27 and select UTILITIES from the CE OPTIONS Menu, then select DISP
SENSORS from the CE UTILITIES Menu.
9C Magazine global sensor pair (A) 90% T31 (0.2) CARR-41
97 Library control card 6% T15 (0.1) CARR-38
A5 Library sensor cable 4% T04 (0.4) CARR-50
Clear
Picker
Path B
The device detected the presence of a possible blockage in the cartridge path between the drive and the picker,
or between the cleaner cell and the picker.
1. Check the position of the cleaner cartridge and ensure that it is fully seated within the cleaner cell. If the
cleaner cartridge is not fully seated in the cleaner cell, replace the cleaner cell retention spring (P/N
05H2912).
2. Ensure that no cartridges or other obsticles are in the picker path between the drive and the picker.
3. Check for a binding or sticking cartridge door.
4. Before replacing FRUs below, ensure that the global, picker and loader sensors are operating correctly. See
Figure 130 on page PANEL-27 and select UTILITIES from the CE OPTIONS Menu, then select DISP
SENSORS from the CE UTILITIES Menu.
9B Drive global sensor pair (B) 90% T31 (0.2) CARR-41
97 Library control card 6% T15 (0.1) CARR-38
A5 Library sensor cable 4% T04 (0.4) CARR-50
Wrong
Mode
An operation was requested from the initiator which cannot be run with the current mode setting.
— — 100% Q05 Change mode to Auto, Random,
or Manual as needed.
No
Magazine
1, 2, or
Both
1. Ensure that the appropriate magazine is properly installed and latched in place. If the ATTENTION LIBRARY
message persists, try a different magazine. If a different magazine fails to correct the problem, replace the
FRUs below: HINT: If both magazines are present, but neither is being sensed, the problem is not likely
to be the sensor or cable.
2. Before replacing FRUs below, ensure that the magazine sensors are operating correctly. See Figure 130 on
page PANEL-27 and select UTILITIES from the CE OPTIONS Menu, then select DISP SENSORS from the
CE UTILITIES Menu.
A0 Magazine 2 sensor 44% T31 (0.2) CARR-48
A1 Magazine 1 sensor 44% T31 (0.1) CARR-49
97 Library control card 6% T15 (0.1) CARR-38
A5 Library sensor cable 4% T04 (0.4) CARR-50
START-26
IBM 3570 MI