IBM Aptiva 2174, Hardware Maintenance Service

Page: 37 / 186

General Information 5
Power Management
• ACPI 1.0/PC99/OnNow compliant motherboard and BIOS.
•
SMM, VESA monitor specification compliant.
• APM 1.2 support with password restart option.
•
Software shutdown by Windows 98.
• Power-on Switch must support Soft-Off and Full-Off.
- Touch for 1 second or less to put system on Suspend state.
- Touch and hold for 4 seconds to put system on Full-Off state (Power
Supply 5V standby remained).
•
System enters standby mode if any of following conditions are met:
- Execute standby from Windows 98 Start menu
- Press system power button if it sets to act as standby function
- System is idle and the standby timer set in the Windows 98 Power
Management Property elapses
Power Supply
•
PC-98 compatible 200W ATX power supply
• Searchable high/low voltage selection
Internal Cabling
•
Two 40-pin ribbon cables for hard disk drives and CD/DVD-ROM drive.
• One 34-pin ribbon cable for AT diskette drive.
•
One 4-pin (2-wire) cable for hard disk drive light-emitting diode (LED).
• One 3-pin (3-wire) cable for power light-emitting diode (LED).
•
One 2-pin (2-wire) cable for power switch.
• One 4-pin modem voice-in/speaker-out cable.
•
56.6 Kbps PCI modem adapter card with data/fax/voice or non-voice
features.
Monitor (Not included with some models)
•
Super Video Graphics Array (SVGA) monitor.
• VESA power saving mode compliant.
•
Connector for a detachable grounded 3-wire power cord
• 1.8-m (5.8-ft.) signal cable attached
•
Auto-sensing power input for 100 Vac to 240 Vac