IBM Aptiva 2159, Hardware Maintenance Service

Page: 172 / 214

Hard Disk Drive Jumper Settings
Up to four drive devices (hard disk, CD-ROM, or Zip drives) can be installed
in Service Level A systems. If any drives do not show in the Installed
Devices list in the Setup Utility, ensure the jumper settings and connectors
are set as shown here. Refer to “System Board Layout” on page 5-2 for
connector location information.
Primary Hard Disk Drive IDE Local Bus Connector
At the primary hard disk drive IDE connector, make sure the first drive
installed is set as the master drive (
.1/
in the following figures).
Note: If a second drive is installed, it must be attached to the secondary
IDE connector. Set the jumpers as the slave drive (
.2/
in the
following figures).
All recovery preloaded software should be installed on the master hard disk
drive on the primary connector.
Secondary Hard Disk Drive Connector
If additional drives are connected to the secondary hard disk drive
connector, set the first drive connected to this connector as the master drive
(
.1/
in the following figures). If a second drive is connected to the
secondary hard disk drive connector, set the jumpers as the slave drive (
.2/
in the following figures). Ensure all software is set to recognize all installed
drives.
For non-internal Zip models, the CD-ROM drive is connected to the
secondary drive connector at the factory as the master drive. If an additional
hard disk drive is connected to the secondary connector, it must be set as
the master drive,
.1/
, and the CD-ROM drive jumpers reset as the slave
drive (see “CD-ROM Drive Jumper Settings” on page 5-13).
Note: Check the Setup Utility for correct installation:
Hard Disk 1 Master drive
Hard Disk 2 Slave drive
Hard Disk 3 Master drive (CD-ROM if other drive not connected to this
connector. Also, Zip drive with internal Zip drive models)
Hard Disk 4 Slave drive (CD-ROM if hard disk or internal Zip drive
installed at secondary connector, Hard Disk 3)
5-10
All manuals and user guides at all-guides.com