4.
Verify that all the IP address information is correct by entering
ipAddrShow
and checking the results
against the IP information recorded in the config-miscinfo.txt file.
switch:admin> ipaddrshow
SWITCH
Ethernet IP Address: 14.25.60.14
Ethernet Subnetmask: 255.55.0.0
Gateway IP Address: 14.25.43.1
DHCP: Off
Verifying correct configuration of the fabric
About this task
Copying the command outputs from this section into a file is recommended. You must be logged in with
Admin privileges.
Procedure
1.
Create an "after" SAN profile by entering the following commands and copying the output to a text
file named SANafter.txt:
v
nsShow
v
nsAllShow
v
switchShow
v
fabricShow
v
lscfg --show
(if using the Virtual Fabric feature)
switch:admin> nsshow
Type Pid
COS
PortName NodeName TTL(sec)
N
020f00;
3;10:00:00:01:73:00:29:46;10:00:00:01:73:00:29:46; na
Fabric Port Name: 20:0f:00:60:69:90:03:f0
<output truncated>
switch:admin> nsallshow
{
020f00 021fda 021fdc 021fe0 021fe1
5 Nx_Ports in the Fabric}
switch:admin> switchshow
switchName: rsl8-st03-01
<output truncated>
switch:admin> fabricshow
Switch ID Worldwide Name Enet IP Addr FC IP Addr Name
<output truncated>
switch:admin>lscfg --show
Created switches: 128(ds) 1 2(bs)
Port
0
1
2
3
4
5
6
7
8
9
-------------------------------------------------------------------
FID
1 | 1 | 1 | 1 | 1 | 128 | 128 | 128 | 128 | 128 |
<output truncated>
switch:admin>
2.
Determine any differences between the information in the SANafter.txt file and the information in the
SANbefor.txt file created earlier. In particular, look for differences in the following:
v
Device types
v
Number of devices
v
ISL and port states
v
Number of switches in the fabric
3.
Resolve any issues or unintentional changes to the device or fabric:
v
If there are any mechanical problems, try reseating the associated component.
v
If the configuration information is not correct for the device, modify as required.
78
SAN128B-6 Installation, Service, and User Guide
Summary of Contents for 8960-F96
