IBM 8364 E series, User Manual, Page: 34 / 150

Removing the power supply:
Notes:
1. Only IBM-authorized personnel should
remove the power supply.
2. You will need a Phillips head screwdriver for
the following procedure.
1. Complete the procedure, “Removing the logic
unit to install parts” on page 18 before
continuing.
2. Disconnect the power supply connector
«A¬
from the logic board.
Pinch the top of the power supply connector
as you disconnect it from the logic board.
This releases the power supply connector
latch.
3.
Remove the two screws
«B¬
attaching the
support plate
«C¬
to the power supply
«D¬
.
4. Pull the support plate
«C¬
out of the logic
unit and set it aside.
5. Remove the three screws
«E¬
attaching the
power supply to the logic unit.
6. Push the power supply toward the front of
the logic unit until it stops.
7. Carefully remove the power supply from the
logic unit.
8.
Continue with the procedure, “Installing the
power supply” on page 23.
22
IBM Network Station