IBM 8248-L4T, Manual

Page: 92 / 214

v
If the disk drive filler has a bezel attached, remove the bezel. For instructions, see “Removing a disk
drive bezel from a disk drive or filler” on page 79.
v
Return to the procedure that brought you here.
Installing a disk drive filler in the 8248-L4T, 8408-E8D, or 9109-RMD
Learn how to install a Small Computer System Interface (SCSI) disk drive filler in the system or
expansion unit.
Note: Some of the figures in these procedures might not look exactly like the system or expansion unit
that you have. However, the steps to complete the task are the same.
1.
If the disk drive bezel is present, complete the following steps:
Attention:
v
Attach a wrist strap to an unpainted metal surface of your hardware to prevent electrostatic
discharge (ESD) from damaging your hardware.
v
When using a wrist strap, follow all electrical safety procedures. A wrist strap is for static control. It
does not increase or decrease your risk of receiving electric shock when using or working on
electrical equipment.
v
If you do not have a wrist strap, just prior to removing the product from ESD packaging and
installing or replacing hardware, touch an unpainted metal surface of the system for a minimum of
5 seconds.
a. Attach the disk drive bezel (A) to the filler.
b. Press in and then tighten the thumbscrew (B) to secure the bezel to the drive.
c.
Install the disk drive bezel latch
(C)
onto the front of the filler, as shown in the Figure 46 on page
77.
Figure 45. Removing a disk drive filler from the system
76
Disk drives or solid-state drives