IBM 8038, Installation And User Manual

Page: 56 / 104

To remove a storage interface card, complete the following steps:
1.
Before you begin, read “Safety” on page v and “Installation guidelines” on
page 17.
2. If the blade server is installed in a BladeCenter unit, remove it (see “Removing
the blade server from the BladeCenter unit” on page 19 for instructions).
3. Remove the blade server cover (see “Removing the blade server cover” on page
20 for instructions).
4. If an optional expansion unit is installed, remove the expansion unit (see
“Removing an optional expansion unit” on page 23).
5. Locate the storage interface card installed in the CIOv connector on the system
board (see “Blade server connectors” on page 15).
6. Gently push the retaining clips away from the expansion card; then, lift the
card out of the expansion-card connector.
Installing a storage interface card
Use this information to install a storage interface card in the blade server.
For more information about the ServeRAID H1135, see the Installation and User's
Guide for ServeRAID H1135 at http://www-947.ibm.com/support/entry/portal/
docdisplay?brand=5000008&lndocid=MIGR-5088601 .
The storage interface card controls the SAS/SATA hot-swap storage drives. The
following illustrations and installation instructions show how to install a
ServeRAID H1135 controller into the CIOv expansion connector of the blade server.
The illustrations and installation instructions are similar for other CIOv storage
interface cards.
42
BladeCenter HS23E Type 8038 and 8039: Installation and User's Guide