IBM 7944, Installation And User Manual

Page: 60 / 150

DIMM air baffle
Baffle pin hole
Baffle pin
Figure 27. DIMM air baffle removal
Step 4. Remove it from the server and set it aside.
Attention:
For proper cooling and airflow, replace the air baffle before you turn on the server.
Operating the server with an air baffle removed might damage server components.
Removing the microprocessor 2 air baffle
Use this information to remove the microprocessor 2 air baffle.
To remove the microprocessor 2 air baffle, complete the following steps:
Step 1. Read the safety information that begins on “Safety” on page iii and “Installation guidelines” on page
41 .
Step 2. Turn off the server and peripheral devices and disconnect the power cords and all external cables.
Step 3. Lift the air baffle up, making sure that the tab comes out of the hole on the side of the power-supply
cage; then, remove the air baffle from the server and set it aside.
Attention:
For proper cooling and airflow, replace the air baffle before you turn on the server.
Operating the server with the air baffle removed might damage server components.
50
System x3550 M3Installation and User's Guide