IBM 7383, Installation And Service Manual

Page: 57 / 488

5. When the media door is unlocked, the icon on the side of the bezel will be in
the unlocked position.
Removing the left-side cover
Use this information to unlock and remove the left-side cover by using the key
that comes with the server.
Before you begin
Important: Before you install optional hardware devices, make sure that the server
is working correctly. Start the server and make sure that the operating system
starts, if an operating system is installed, or that a 19990305 error code is
displayed, indicating that an operating system was not found but the server is
otherwise working correctly. If the server is not working correctly, see “Running
DSA Preboot diagnostic programs” on page 149 for information about how to run
diagnostics.
Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 34.
If you are replacing a component or installing an optional device in the server, you
need to turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
About this task
Attention: The server automatically powers off when the left-side cover is
removed.
To remove the left-side cover, complete the following steps.
Procedure
1. Unlock the left-side cover, using the key that comes with the server.
2. Pull the cover-release latch down while you rotate the top edge of the cover
away from the server; then, lift the cover off the server.
Chapter 2. Installing optional devices
39