IBM 6400i, Setup Manual

Page: 51 / 370

Setting Rear Paper Exit
51
Setting Rear Paper Exit
1. Press Stop to place the printer in NOT READY state.
NOTE: If there is paper in the printer, unload the paper, then continue with
step 2 of this procedure.
Figure 24. Loosening the Hinge Thumbscres, Open View of the Back Rear Pedestal Model
Cover
2. Open the printer cover.
3. Loosen the two hinge adjustment thumbscrews.
4. Slide the cover forward until it stops.
Figure 25. Internal View of the Pedestal Model Showing Paper Exit Options
5. Tighten the two hinge adjustment thumbscrews.
6. Place the paper guide in its lower position.
Thumbscrew