IBM 6400-i05, Setup Manual

Page: 52 / 370

52
Chapter 2
Connect The Interface And Power Cables (Cabinet Models)
Figure 26. Top Back View of the Pedestal Model with Paper Exiting through the Rear
7. Load the paper (see page 66), feeding the paper out of the rear paper
exit.
Connect The Interface And Power Cables (Cabinet Models)
1. Verify that the voltage source at the printer site conforms to the
requirements specified on page 28. Make sure that the printer power
switch is set to OFF. See Figure 29 on page 54.
2. Open the front cabinet door, remove and open the cardboard box
containing the power cord, printer ribbon, and operator panel overlay
label. Refer to “Printer Specifications” on page 289 for recommended
cables. Documentation is stored in a pouch container on the left interior
side of the cabinet.
<1> Before powering on the printer, ensure the printer is plugged into
an appropriate power source. Refer to page 27 for information on
the proper source.
<4> Do not connect or disconnect any communication port, teleport,
attachment connector, or power cord during an electrical storm.
<5> Power off the printer and disconnect the power cord before
connecting or disconnecting communication port, teleport, or
attachment cable connector.
DANGER