IBM 6400-i05, Setup Manual

Page: 233 / 370

Serial Matrix Emulation Menu
233
Auto LF
The Auto LF option defines the printer action when print data is received past
the forms width setting.
•
Enable (the default). Performs an automatic carriage return and line feed
when data is received past the forms width.
•
Disable. Discards any data past the forms width.
Overstrike
This option enables you to print bold characters.
•
Enable (the default). Turns on bold print. When enabled, overstrike
printing slows down the printer.
•
Disable. Turns off bold print.
Define LF Code (Line Feed)
•
LF = LF (the default). Does not perform an automatic carriage return
when a line feed command is received. The next print position will be the
current print position of the next line.
•
LF = CR + LF. Forces an automatic carriage return with each line feed
command received. The next print position is print position 1 of the next
line.
Printer Select
•
Disable (the default). Ignores the ASCII DC1 and DC3 control codes.
•
Enable. Disables the printer when a DC1 control code is received, and
enables the printer when a DC3 control code is received.
Alternate Set 80-9F
•
Control Code (the default). Interprets data in the range of hex 80 through
hex 9F as a control code.
•
Printable. Prints data in the range of hex 80 through hex 9F.