IBM 6400-i05, Setup Manual

Page: 148 / 370

148
Chapter 4
3270 Interface Menu
Lead-In Characters
The Lead-In Character commands must have a start and end code. Set 1 is
the factory default. Three sets (each containing a start and end code) are
available:
•
Set 1: start code = <%
end code = >
•
Set 2: start code =
¬¬
end code = $
•
Set 3: start code = _%
end code = _
•
User Defined
User Defined Codes
•
Start Code 2: 5F (the default)
•
Start Code 1: 5F (the default)
•
Stop Code: 5B (the default)
The codes have a range of x’40’ - x’FF’.
Alternate Set 80 - 9F
This selection determines if ASCII codes 80 hex through 9F hex will be used
as control codes or printed as standard printable characters.
•
Printable (the default). Prints the alternate set as standard characters
•
Control Code. Selects the alternate set to be used as printer control
codes.
Mono/Dual Case
Specifies the font as Mono or Dual case. This option is available only in non-
SCS mode. The host will be notified of the change when the printer is placed
online. Mono Case prints the same as Dual Case if the character set is one of
the following “right to left” sets: Katak., Hebrew, Old Hebrew, and Farsi.
SCS (System Network Architecture Character String) mode is controlled by
the host computer.
•
Dual Case (the default)
•
Mono Case