IBM 6000 VA LCD 4U, Installation And Maintenance Manual

Page: 35 / 88

Turning on the UPS
After the UPS is connected to the power source, it enters Standby mode.
To turn on the UPS, press the on/off button for approximately 1 second. The display
changes from the start screen to the UPS Status Summary screen and shows the
Standby icon flashing while the UPS starts.
Starting the UPS on battery
Note: Before you use this feature, the UPS must have been powered by utility
power at least one time.
To turn on the UPS without using utility power, press and hold the on/off button for
3 seconds. The UPS supplies power to the connected devices, and it switches into
Battery mode.
Turning off the UPS
To turn off the UPS, complete the following steps:
1. Prepare the connected devices for shutdown.
2. Press and hold the on/off button until the long beep ceases (approximately 3
seconds). The UPS switches to Standby mode (if utility power is available) and
removes power from the connected devices.
Note: You must turn off the UPS at the power source; otherwise, it remains in
Standby mode. After the power source is removed, the UPS fully shuts down in
10 seconds.
Display functions
The UPS provides information about the load status, events, measurements,
identification, and settings through the front panel display.
While any screen is displayed, press the escape (X) button until the main menu is
displayed, and then press the down (
) button to scroll through the following main
menu choices:
v System Status
v
Alarm History
v Meters
v
Control Screens
v
Model Information
v Configuration
Press the OK button to select a menu item.
Chapter 3. Operating the uninterruptible power supply
21