IBM 4mm DDS-2 Tape Autoloader, Installation And User Manual

Page: 12 / 52

Software Requirements
The 4mm DDS-2 Tape Autoloader requires AIX Version 4.2 or later. The tape drive
can be used with the backup, restore, cpio, and tar commands by manually loading
and unloading.
The complete tape autoloader (tape drive and media changer) can be used for
save/restore operations with appropriate applications.
Handling the Tape Drive
Attention: Static electricity can damage your equipment. Leave the tape drive in its
static-protective bag until you are ready to configure or install it in your computer.
Drive Preparation
Attention:
Ÿ
Never remove, install, or transport the 4mm Tape Autoloader with tape cartridges
loaded in the magazine. They can become dislodged and jam the mechanism.
Ÿ
If the tape autoloader is moved from a colder or warmer environment than which
it will be installed, keep the drive in its packing and allow the package to reach
room temperature. This will avoid data loss or damage to the tape drive. Allow
one hour of acclimation for each 10 degrees C (18 degrees F) difference
between the ship/store temperature and the room temperature.
Ÿ
Handle the drive carefully and by its external metal chassis. Keep hands away
from printed circuit boards, components, and printed circuit (flex) cables.
Ÿ
Use a cushioned work surface if possible and do not drop the tape drive onto the
work surface.
1-4
4mm DDS-2 Tape Autoloader Installation and User's Guide