IBM 4957-J10, Manual

Page: 37 / 70

Contact IBM support to make sure suitable mounting rails are available for the rack you are to use.
Installing the enclosure
1. Remove the rack mounting rail kit from the accessories box and examine for damage.
2. Use the procedure given below to attach the rack brackets to the rack posts.
a. Set the location pin at the rear of the rail into a rear rack post hole. Attach the bracket to the rear
rack post: use the washers and screws supplied.
Note: Leave the screws loose.
b. Extend the rail to fit between the front and rear rack posts.
c. Attach the bracket to the front rack post using the washers and screws supplied.
Note: Leave the screws loose.
d. Tighten the two clamping screws located along the inside of the rear section of the rack bracket.
Figure 15. Securing brackets to rail
3. Install the enclosure into the rack as follows.
a. Lift the enclosure and align it with the rack rails.
b. Carefully insert the chassis slides into the rack rails and push fully in to secure.
c. Tighten the mounting screws in the rear rack bracket.
Chapter 3. Installation 17