IBM 4348, User Manual

Page: 16 / 70

Features and specifications
The following information is a summary of the features and specifications of the
server. Depending on the server model, some features might not be available, or
some specifications might not apply.
Table 1. Features and specifications
Microprocessor:
v
One Intel LGA775 dual-core Xeon
E2140 or 3065 series processor
v 2 MB, 3 MB, 4 MB, or 6 MB Level-2
cache
v 1066 or 1333 MHz front side bus
Note: Use the Configuration/Setup
Utility program to determine the type
and speed of the microprocessor.
Memory:
v
Minimum: 512 MB
v
Maximum: 8 GB
v
Types: Unbuffered PC2-5300, 667
MHz or PC2-6400 800 MHz ,
double-data-rate 2 (DDR2) with ECC
v
Connectors: four dual inline memory
module (DIMM) connectors, two-way
interleaved
Drives: (depending on your model)
v
Hard disk drive: SATA
v
Optional tape drive: SATA
v
One of the following SATA drives:
– DVD-ROM
– DVD/RW
Drive bays: (depending on your model)
v Two 5.25 in. bays: optical drive (one
DVD drive installed)
v One 3.5 in. removable-media drive
bay; optional external tape drive
v Two 3.5 in. hard disk drive bays (one
hard disk drive installed)
Expansion slots:
v Two PCI Express x8 slots
v Two PCI 32-bit/33 MHz slots
Video controller : ATI ES1000 video
controller with 32 MB SDRAM video
memory on the system board
Fans: One speed-controlled fan
Power supply: One 310 watt (90 - 240 V
ac)
Important: Make sure that the ac
power-supply input voltage is set to the
correct level (at 115 V ac and 230 V ac)
for your geographic location before you
turn on the server.
Size:
v Height: 420 mm (16.54 in.)
v Depth: 448 mm (17.64 in.)
v Width: 175 mm (6.89 in.)
v
Weight: 14 kg (30.86 lb) to 17 kg (37.48
lb) depending upon configuration
Integrated functions:
v Intel 10/100/1000 Ethernet controller on
the system board with RJ-45 Ethernet
port
v One serial port
v One parallel port
v Four-port Serial ATA II controller
v Six Universal Serial Bus (USB) v2.0
ports (two on front and four on rear)
v One internal USB port for tape drive
v ATI ES1000 video
– Compatible with SVGA and VGA
– 32 MB DDR2 video memory
Diagnostic LEDs:
v
Fans
v
Memory
Acoustical noise emissions:
v Sound power, idling: 5.0 bel
v Sound power, operating: 5.3 bel
Environment:
v
Air temperature:
– Server on: 10° to 35°C (50.0° to 95.0°F)
Altitude: 0 to 914.4 m (3000 ft)
– Server on: 10° to 32°C (50.0° to 89.6°F)
Altitude: 914.4 m (3000 ft) to 2133.6 m
(7000 ft)
– Server off: 10° to 43°C (50° to 109°F)
Maximum altitude: 2133.6 m (7000 ft)
– Shipping: -40° to 60°C (-40° to 140°F)
v Humidity:
– Server on: 8% to 80%
– Server off: 8% to 80%
Heat output:
Approximate heat output in British thermal
units (Btu) per hour
v
Minimum configuration: 185 Btu per hour
(54 watts)
v Maximum configuration: 853 Btu per hour
(250 watts)
Electrical input:
v
Sine-wave input (50 or 60 Hz) required
v
Input voltage and frequency ranges
manually selected
v
Input voltage low range:
– Minimum: 100 V ac
– Maximum: 127 V ac
v
Input voltage high range:
– Minimum: 200 V ac
– Maximum: 240 V ac
v
Input kilovolt-amperes (kVA) approximately:
– Minimum: 0.10 kVA (all models)
– Maximum: 0.50 kVA
Notes:
1. Power consumption and heat output vary
depending on the number and type of
optional features that are installed and the
power-management optional features that
are in use.
2. These levels were measured in controlled
acoustical environments according to the
procedures that are specified by the
American National Standards Institute
(ANSI) S12.10 and ISO 7779 and are
reported in accordance with ISO 9296.
Actual sound-pressure levels in a given
location might exceed the average values
stated because of room reflections and
other nearby noise sources. The declared
sound-power levels indicate an upper limit,
below which a large number of computers
will operate.
4
System x3100 Type 4348: User’s Guide