IBM 4247 Model 003, User Manual

Page: 93 / 392

2. When changing the value of the Printer Address, verify the Data Stream and
the Emulation Mode you have set.
You can set the Printer Address to any of the following values.
v
000 (Default)
v
001
v
002
v
003
v
004
v
005
v
006
To change or check the printer address setting, follow these steps:
1. Press Menu.
2.
Press Scroll
↑
or Scroll
↓
until the printer displays
CONFIGURATION MENU
Twinax Configuration
3. Press Enter.
4. Press Scroll
↑
or Scroll
↓
until the printer displays
Twinax Configuration
Printer Address
5.
Press Enter to display the current value.
6. Press Scroll
↑
or Scroll
↓
until the desired value for printer address is displayed.
7.
Press Enter.
An asterisk (*) will be displayed in front of the selected value.
8. Press Start or Return to exit the Menu. See “Exiting the Configuration Menu”
on page 55.
Data Stream
This parameter is available only if the IPDS
™
feature is installed.
You can set the Data Stream to the following values:
v
IPDS (Default)
v
SCS
Notes:
1. The printer performs a partial reset to put any change to this parameter value
into effect when you exit the Configuration Menu with Start or Return.
Buffered data will be lost.
2. When changing the value of the Data Stream, verify the Emulation Mode and
the Printer Address you have set.
To change or check the data stream, follow these steps:
1.
Press Menu.
2. Press Scroll
↑
or Scroll
↓
until the printer displays
CONFIGURATION MENU
Twinax Configuration
Chapter 7. Twinaxial Configuration
83