IBM 4247 Model 003, User Manual

Page: 16 / 392

6. Remove the three plastic shipping blocks (packing) from each side in the front
tractor area.
Handling Attachment Card
Attention: Do not remove the attachment card from the protective package until
instructed to do so.
Static electricity, though harmless to you, can damage sensitive attachment-card
components. Use the information in this section to avoid damaging an attachment
card.
v
Limit your movement. Your movement can create static electricity that, when
released to the attachment card, can damage the electronic components on the
attachment card. Sliding your foot across carpeting is an example of how you
create unwanted static electricity.
v
Handle the attachment card only by the edges and prevent others from making
direct contact with it.
v
Before removing the attachment card from the protective package, ground the
package to exposed metal at the back of the printer. This will release any static
charge that may have developed on the package or on your body. Hold the
package against the metal for at least two seconds.
v
When you are instructed, remove the attachment card and install it directly into
the attachment card slot without setting it down. If you have removed the
attachment card from the protective package and cannot immediately insert it in
the printer, place the protective package on a flat surface, and set the attachment
card on top of the protective package.
E61A5003
Packing
e61a0051
Figure 2. Front Tractor Packing
6
4247 Model 003 User’s Guide