IBM 4002-C2A, Installation And User Manual

Page: 35 / 98

configuration or operation of the feature. If a port’s region does affect
configuration or operation of a feature, it is noted and described in the appropriate
feature section of this guide.
IBM Ethernet Switch B24C:
v
Ports 1-24 (1 GbE ports)
v Port 2/1 (optional 10 GbE port)
v
Port 2/2 (optional 10 GbE port)
IBM Ethernet Switch B48C:
v
Ports 1/1 - 1/24 (1 GbE ports)
v Ports 1/25 - 1/48 (1 GbE ports)
IBM Ethernet Switch B50C:
v
Ports 1/1 - 1/24 (1 GbE ports)
v Ports 1/25 - 1/48 (1 GbE ports)
v
Port 1/2 (10 GbE port)
v Port 2/2 (10 GbE port)
Power supplies
Each switch comes with one 500 W alternating-current (AC) power supply. All
models have two power supply slots, enabling you to install a second power
supply for redundancy.
The power supplies are hot-swappable and can be swapped in or out of the device
while the device is running. You can remove and insert a power supply without
opening the chassis. A single power supply provides enough power for the entire
system.
The following sections provide further details about the power supplies for the
switches:
v Power status LEDs are listed in “Observing the power status LEDs” on page 22.
v
Hardware specifications for the power supplies are listed in “Hardware
specifications,” on page 61.
v
“About redundant power supplies and power supply failure” on page 10.
AC power supplies
The slot for an optional second power supply is covered by a cover plate. To
provide redundancy, the optional second power supply can be ordered.
Figure 7 on page 10 shows a rear view of a device containing one AC power
supply. The slot for an optional second power supply is covered by a cover plate.
To provide redundancy, an optional second power supply can be ordered.
Chapter 2. Product overview
9
|
|
|
|
|
|
|
|
|
|
|