IBM 2283, Hardware Maintenance Service

Page: 97 / 213

Check Procedures 65
CD/DVD-ROM Drive
001 - START
•
Run the Diagnostics program located in service
partition.
•
Select Interactive Tests menu, then select and
execute CD/DVD-ROM Test.
002 - DO YOU SEE A MESSAGE “NO CD/DVD-
ROM DRIVE OR MSCDEX DEVICE DRIVER
INSTALLED.”? (YES, READ AHEAD. NO, GO TO
003.)
•
Exit the diagnostics program and power off the
system.
•
Check and ensure that the CD/DVD-ROM drive
power cable and audio and data cables are not
damaged and are connected properly.
•
Check and ensure that the CD/DVD-ROM drive
driver is loaded correctly.
•
Load default settings.
003 - DO THE TESTS OF OPEN/CLOSE TRAY BY
DIAGNOSTICS PROGRAM AND BY DEPRESSING
CD/DVD-ROM DRIVE BUTTON WORK? (YES,
READ AHEAD. NO, GO TO STEP 006.)
•
Load a known good data CD/DVD into the CD/
DVD-ROM drive and try to read its content by
typing DIR at DOS prompt.
004 - CAN A CD/DVD BE READ FROM THE CD/
DVD-ROM DRIVE? (YES, THEN THE CD/DVD-ROM
DRIVE FUNCTIONS NORMALLY. NO, READ
AHEAD.)
•
Try reading the CD/DVD with a known good CD/
DVD-ROM drive.