IBM 2145-4F2, Installation Manual

Page: 103 / 143

1
Power connector
2
Serial connector
3
Output connector
4
Signal cable connector
2. Plug the signal cable of the power cable assembly into the serial connector
2
.
DANGER
You have already switched on the 2145 UPS. The output sockets of the
2145 UPS are live.
3.
Place the other end of the SAN Volume Controller 2145-4F2 power cable into
any vacant output connector
3
on the 2145 UPS.
4. Place the other end of the signal cable into any vacant position on the top row
of serial connectors
4
on the 2145 UPS.
Attention: Do not plug any signal cables into the bottom row of signal cable
connectors or the 2145 UPS malfunctions.
The SAN Volume Controller 2145-4F2 power is now connected to the 2145 UPS.
Related tasks
“Inspecting the SAN Volume Controller for unsafe conditions” on page xii
Use caution when working in any potential safety hazardous situation that is
not covered in the safety checks. If unsafe conditions are present, determine
how serious the hazards are and whether you can continue before you correct
the problem.
“External machine check” on page xiii
Ensure that you perform an external machine check before you install the SAN
Volume Controller.
“Internal machine checks” on page xiii
Ensure that you perform an internal machine check before you install the SAN
Volume Controller.
2
1
3
4
Figure 50. Connecting the SAN Volume Controller 2145-4F2 power cable to the 2145 UPS
Chapter 4. Installing the UPS, the master console, and the SAN Volume Controller
73