IBM 11000 VA LCD 5U, Installation And Maintenance Manual

Page: 46 / 92

Model information
The model information screens display the following information about the UPS:
v Model/Type: Chassis style and supply power rating
v MT, Product ID, SN: Machine type, product identification (model number), serial
number
v
NMC firmware: Firmware version for the network management card
v NMC IP address: IP address for the network management card
v
UPS firmware: Firmware version for the UPS
Note: The network management card firmware screens are displayed only if an
IBM Network Management Card is installed. See “IBM Network Management Card”
on page 45.
Configuration
Only the available options are displayed.
User settings are not protected by default. You can enable the password through
the User Password setting.
The following table describes the options that you can change.
Table 8. Configuration settings
Description Available settings Default setting
Change language [English] [French] [German] [Spanish] [Japanese] [Simplified
Chinese] [Russian] [Korean] [Traditional Chinese] English
User password [Enabled] [Disabled]
If the user password is enabled, the default password is USER.
Note: If you enter an incorrect password, the message Wrong
Password
is displayed. Press any button to return to the password
screen and retry the password.
Disabled
Audible alarms [Enabled] [Disabled]
Note: If you disable audible alarms, it takes effect instantly and
remains disabled, even after a power cycle. This differs from the
mute feature, by which the horn is temporarily silenced when any
button is pressed but turns on again if a new alarm is triggered.
Enabled
Set date and time Set the month, day, year, hours, minutes, and seconds
Date: mm/dd/yyyy 01/01/2010
Time: hh:mm:ss 12:00:00
Notes:
1. The date format is dependent on the language selection.
2. Time is a 24-hour clock.
Control commands
from serial port [Enabled] [Disabled]
If enabled, control commands are accepted through the serial
port, USB ports, or option card.
If control commands are disabled, configuration and load control
commands are restricted to LCD only.
Enabled
32
11000 VA UPS and 11000 VA EBM: Installation and Maintenance Guide