©Copyright LOTRONIC 2016
LMH-MINIWASH
Page 5
188-217
Motor Sound control 1
218-255
Motor Sound control 0
15
0-255
Motor auto running speed from fast to slow
16
LED Auto/Sound control
0
Other Channels work
1-7
Gradual Change
7-39
LED Auto running 0
40-72
LED Auto running 1
73-105
LED Auto running 2
106-138
LED Auto running 3
139-140
LED Auto running 4
141-167
LED Sound control 0
168-195
LED Sound control 1
196-223
LED Sound control 2
224-251
LED Sound control 3
252-255
LED Sound control 4
17
0-255
LED Auto running speed from slow to fast
18
250-255
Reset after 5s
3. SETUP
Disconnect the power cord before replacing a fuse and always replace with the same type fuse.
3.1 Fuse Replacement
With a flat head screwdriver wedge the fuse holder out of its housing.
Remove the damaged fuse from its holder and replace with exactly the same type of fuse.
Insert the fuse holder back in its place and reconnect power.
The fuse is located inside this compartment. Remove using a flat head screwdriver.
3.2 Fixture Linking
You will need a serial data link to run light shows of one or more fixtures using a DMX-512 controller or to run
synchronized shows on two or more fixtures set to a master/slave operating mode. The combined number of
channels required by all fixtures on a serial data link determines the number of fixtures that the data link can
support.
Important
: Fixtures on a serial/data link must be daisy chained in one single line. Maximum recommended serial
data link distance: 500 meters (1640 ft.) Maximum recommended number of fixtures on a serial data link: 32 fixtures
Data Cabling
To link fixtures together you must use data cables. If you choose to create your own cable, please use data-grade
cables that can carry a high quality signal and are less prone to electromagnetic interference.
CABLE CONNECTORS
Cabling must have a male XLR connector on one end and a female XLR connector on the other end.
