Hardware Configuration
UPC-7210 Series User Manual
9
2
Avoid device disassembly:
Disassembly, modification, or any attempt at repair
could generate hazards and cause damage to the device, injury, or property damage,
and will void any warranty. If you need to make any changes to the device, be sure to
unplug the power cord of the device and have qualified engineers or technicians do
the disassembly or installation.
2.1 Rear Cover Disassembly
In case you need to remove the rear cover to install or replace a memory
module or a mini-PCIe card, unscrew the 16 screws as shown below to
remove the rear cover. Take extra care to open the rear cover.
2.2 Memory Replacement
To replace or install memory modules, perform the following steps after
removing the system rear cover.
1. Locate the memory slot and align the key of the memory module with
that on the memory slot.
2. Insert the module slantwise and gently push the module straight down
until the clips of the slot close to hold the module in place when the
module touches the bottom of the slot.
.
To remove the module, press the clips outwards with both hands.