IBASE Technology MPT-500R, User Manual, Page: 29 / 94

Hardware Configuration
MPT-500R/RH Series User Manual 21
2
2.2 Setting the Jumpers
Set up and configure your MPT-500R by using jumpers for various settings
and features according to your needs and applications. Contact your supplier
if you have doubts about the best configuration for your use.
2.2.1 How to Set Jumpers
Jumpers are short-length conductors consisting of several metal pins with a
non-conductive base mounted on the circuit board. Jumper caps are used to
have the functions and features enabled or disabled. If a jumper has 3 pins,
you can connect either PIN1 to PIN2 or PIN2 to PIN3 by shorting.
A 3-pin jumper A jumper cap
Refer to the illustration below to set jumpers.
Pin Oblique view Illustration
Open
1-2
closed
2-3
closed
When two pins of a jumper are encased in a jumper cap, this jumper is
closed , i.e. turned On .
When a jumper cap is removed from two jumper pins, this jumper is
open , i.e.
turned Off .
Pin# 1
2
3
1 2 3
1 2 3
1 2 3