IBASE Technology ET980 Series, User Manual

Page: 16 / 70

10 ET980 Series User’s Manual
2.1 Installations
2.1.1 Installing the Memory
To replace or install a memory module, locate the memory slot (J2, J4) on the
board and perform the following steps:
1. Align the key of the memory module with that on the memory slot and
insert the module slantwise.
2. Gently push the module in an upright position until the clips of the slot
close to hold the module in place when the module touches the bottom
of the slot.
To remove the module, press the clips outwards with both hands, and the
module will pop-up.