IBASE Technology ASTUT-152-RE1S, User Manual

Page: 19 / 92

10 ASTUT-152-RE1S User Manual
2.1 Hardware Installation
Avoid Disassembly:
You are not suggested to disassemble, repair or make any
modification to the device. Disassembly, modification, or any attempt at repair could
generate hazards and cause damage to the device, even bodily injury or property
damage, and will void any warranty.
If you need to make any change to the
device, be sure to have qualified engineers or technicians for disassembly or
installation.
2.1.1 Memory Installation
There are two SO-DIMM DDR3L memory slots inside ASTUT-152-RE1S and
the maximum memory supported is 8 GB.
The ASTUT-152-RE1S supports two SO- DIMM DDR3L memory slots for a
maximum total memory of 8GB. To install the modules, locate the memory
slot on the board and perform the following steps:
1. Align the key of the memory module with that on the memory slot and
insertl the module slantwise.
2. Gently push the module in an upright position until the clips of the slot
close to hold the module in place when the module touches the bottom of
the slot.
To remove the module, press the clips outwards with both hands.