IBA ibaPADU-D-8AI-U, Manual

Page: 18 / 34

Manual ibaPADU-D-8AI-U/-D-8AI-I
18 Issue 1.4
Pin assignment
X1 Pin... Connection LED X5 Pin... Connection LED
1 Analog input 00 +
AI0
1 Digital input 00 +
DI0
2
Analog input 00 −
2
Digital input 00 −
3 Analog input 01 +
AI1
3 Digital input 01 +
DI1
4
Analog input 01
−
4
Digital input 01
−
5 Analog input 02 +
AI2
5 Digital input 02 +
DI2
6
Analog input 02
−
6
Digital input 02
−
7 Analog input 03 +
AI3
7 Digital input 03 +
DI3
8
Analog input 03
−
8
Digital input 03
−
9 Analog input 04 +
AI4
9 Digital input 04 +
DI4
10
Analog input 04 −
10
Digital input 04 −
11 Analog input 05 +
AI5
11 Digital input 05 +
DI5
12
Analog input 05 −
12
Digital input 05 −
13 Analog input 06 +
AI6
13 Digital input 06 +
DI6
14
Analog input 06 −
14
Digital input 06 −
15 Analog input 07 +
AI7
15 Digital input 07 +
DI7
16
Analog input 07 −
16
Digital input 07 −
7.3.4 Grounding screw X29
Proper connection of cable shielding to the device should be ensured. The shield con-
nector (M6 screw) found on the bottom of the device should be connected with any total
shield that serves for all sensor cables. Use a M6 cable lug for the connection.
Important note!
Connect shield on one cable side only to avoid ground loops!
Always ground the DIN rail on which the device is installed!
7.3.5 Ethernet interface X12
An Ethernet interface, found on the bottom side of the device is dedicated to service
purposes. The Ethernet interface is set as default to the IP address 192.168.1.1.
Important note
The Ethernet cable must not be connected in normal operation mode.