- 11 -
Mounting your iameco
•
Drill the holes. (Refer to the distance between the holes according to the model.)
•
Install the plug, part A and the screws.
•
Install the parts A.
•
Install the screws A on the rear of the LCD-TV.
•
Hang the LCD-TV on the installed part A. The screws on the rear would fit in the holes X on part A.
•
After fitting the screws to the holes let the LCD-TV slide down to the limits on Parts A.
•
Check that it is steady.
It is strongly recommended that you connect all the connection cables before hanging the LCD-TV on the wall.
799 mm
Part A
Plugs
182 mm
Fixing
screws B
Hole X
Fixing
screws A
Distance between holes
Model
Holes
Description
XV1-32
4 holes
799 mm horizontally and 182 mm between the two holes from top to bottom
XV1-40
6 holes
1021 mm horizontally and 50 mm between the first and second holes from top
and 100 mm between the second and the third holes from top
XV1-46
6 holes
1143 mm horizontally and 50 mm between the first and second holes from top
and 100 mm between the second and the third holes from top
Do not fix the TV with other fixations than those provided or suggested by the manufacturer.
Basic operation
•
Use AC 110-240 V 50-60 Hz power outlet for the power supply.
•
If the screen of the TV is not on, please press the power button on the remote control or on the TV.
•
If you want to turn off the TV temporarily, please press the power button on the remote control or on
the TV.
•
If you want to turn off the TV completely, please switch of the power ON/OFF switch.
•
In TV/AV state, the TV will enter idle state if there is no signal input within 15 minutes.
•
In PC state, the TV will enter idle state if there is no signal input within 2 minutes.
•
The setting and tuning of picture and sound will be saved when the TV is shut off, which will be working
in the pre-shut off state when the TV is turn on again.
•
If PC signal source is used, please first set the resolution of the PC display card as the following modes
(1024×768 60 Hz, 800×600 60 Hz, 640×480 60 Hz)
•
If there is line-by-line output of the signal used by the user, signal source with line-by-line output is
recommended.
