IAI R-unit RSEL, Instruction Manual, Page: 371 / 844

Chapter 6 Field Network, PIO, SIO
6.2 Functional Specifications
6-52
ME0392-4C
[9] SIO type
It is the serial communication feature by the SEL program using Free-to-User Channel No. 1.
The general serial communication or the XSEL serial communication protocol (Format B) using
the SEL languages below
(*) are available.
The communication type requires settings established in the parameter (I/O Parameter No. 201
bit 12 to 15).
(It is set to the general serial communication on delivery)
Category Condition Command Operand 1 Operand 2 Output Function
Timer Optional TIMC Program No. Prohibited CP Standby Canceled
Communication
Optional OPEN Channel No. Prohibited CP Channel Open
Optional CLOS Channel No. Prohibited CC Channel Closed
Optional READ Channel No. Column Number CC Input from Channel
Optional TMRW Lead Time (Light Timer) CC REA/WRIT Timeout Setting
Optional WRIT Cannel No. Column Number CP Output to Channel
Optional SCHA
Character
Codes
Prohibited CP
Determination Character Setting
for Data Sending and Receiving
* It is necessary to have the main application part V1.09 or later.
6.3 Parameter Configuration
ME0392-4C
6-53
6.3 Parameter Configuration
6.3.1 Basic setting
(1) I/O slot
● Module Type and Communication Setting
1) Setting Check in Used Network
Check in I/O Parameter No 225.
No. Parameter Name Input range Unit Remarks
225 I/O controller 0H to FFFFFFFFH
Bits 0 to 7: Type of Network I/F Module Control 1
(0H: Not mounted,
1H: CC-Link,
2H: DeviceNet,
3H: PROFIBUS-DP,
4 to 5H: Reserved by the system,
6H: EtherCAT,
7H: EtherNet/IP,
8H: Reserved by the system,
9H: PIO,
AH: PROFINET IO,
B to CH: Reserved by the system,
DH:CC-Link IE Field)
* This parameter is already set at delivery.
2) Node Address and TCP/IP Settings
Set the node address in I/O Parameter No. 226 for CC-Link, CC-Link IE Field, DeviceNet,
EtherCAT and PROFIBUS-DP.
For EtherCAT, set as shown below.
• When having automatic assignment of node address from master: Set 0 (setting at delivery)
• When having fixed assignment of node address: Set 1 to 65,535
No. Parameter Name Input range Unit Remarks
226
I/O1 Fieldbus Node
Address
0 to 99,999,999
Settable Range
•
At CC-Link: 1 to 64
•
At DeviceNet: 0 to 63
• At PROFIBUS-DP: 0 to 125
• At EtherCAT: 0 to 65,535
•
At CC-Link IE: 1 to 120
* Setting establishment not necessary for EtherNet/IP and
PROFINET IO
* The range available for setting should differ depending on the network type to be installed. “60D:
Fieldbus Parameter Error” should occur when a number out of the settable range is indicated.