2.8. PTZ Setup
In the PTZ Setup, the authorized users can configure the RS485 settings of the analog PTZ cameras connected to Annexxus
301 or Annexxus 304 encoders.
Note
PTZ tab is only available for Annexxus 301
and Annexxus 304 models.
To configure the PTZ analog camera connected to the Annexxus 301/304 device, do the following:
1. Select the Channel number (BNC number on Annexxus module), where the PTZ cameras is connected
2. Set the Baud Rate to
9600
3. Set the PTZ Type to
i3 SD
4. Enter the PTZ Address (Dip-switch configured camera ID)
5. Click
Save
to save the PTZ settings
1. For Annexxus 304 modules, select the
Channel number
(BNC number on Annexxus module), where the PTZ cam-
eras is connected
2. From the
PTZ Type
drop-down menu, select one of the supported PTZ protocols (e.g. i3 SD).
3. From the
Baud Rate
drop-down menu, select the baud rate of the PTZ camera. Please refer to the camera's manu-
facturer documentation to determine the correct baud rate setting. Use the table below to determine the baud rate
setting for the known protocols.
Supported Baud Rate
PTZ Protocol
9600
i3 SD
9600
i3 Z1200
48
PTZ Setup
Chapter 2. Remote Connection via SRX-Pro/iP-Pro
Server
XML to PDF by RenderX XEP XSL-FO Formatter, visit us at