2.3. Basic IP Input Setup
After the new IP video source has been added to the list, some parameters may be adjusted:
•
Resolution
. Choose from available resolutions: 352x240, 704x240, 704x480, 1280x720 (Annexxus 301C2M/301D2M
only) and 1600x1200 (Annexxus 301C2M/D2M only).
•
FPS
(frames-per-second rate). This frame rate setting is used for recording. This frame rate is also used on Live Mode,
while IP input is in the full screen mode. When any other screen division is selected, IP input will be displayed at 2
fps rate on live mode.
Use the arrows up/down to increase/decrease frame rate setting. Use the table below to determine the FPS range
depending on set resolution and video frequency.
Supported FPS Range based on Resolution and Video Frequency
FPS Range
Video Frequency
Resolution
1~30 fps
60 Hz
CIF (352x240)
1~25 fps
50 Hz
CIF (352x288)
1~30 fps
60 Hz
2CIF (704x240)
1~25 fps
50 Hz
2CIF (704x288)
1~30 fps
60 Hz
D1 (704x480)
1~25 fps
50 Hz
D1 (704x576)
1~15 fps
60 Hz
1280x720
1~25 fps
50 Hz
1280x720
1~10 fps
60 Hz
1600x1200
1~12 fps
50 Hz
1600x1200
Tip
Frame rate can be set to less than 1 frame
per second in Channels Setup of Annexxus
Advanced Setup.
The FPS setting for each Annexxus 301-series channel may not exceed 30 frames-per-second (with Only P frame type).
Annexxus 301/301C Limitations with SRX-Pro/iP-Pro Server:
• BBP frame type setting (default) allows one camera input with a maximum of 10 fps per input regardless of the
resolution setting.
• Only P frame type setting allows one camera input with a maximum of 30 fps per input regardless of the resolution
setting.
Annexxus 304 Limitations with SRX-Pro/iP-Pro Server:
• 352x240 allows four camera inputs with a maximum of 10 fps per input
27
Basic IP Input Setup
Chapter 2. Remote Connection via SRX-Pro/iP-Pro
Server
XML to PDF by RenderX XEP XSL-FO Formatter, visit us at