IACER Srl
28
MNPG117-02
PROBLEM
POSSIBLE CAUSE
SOLUTION
Display shows
the following
error
Error during the self-
test
Remove any applicators,
switch the apparatus off
and on again. If the
problem persists,
contact the fabricant.
Display shows
the following
picture
No handle is
connected
Check the connection of
applicator/s to the
socket/s. If the problem
persists, contact the
fabricant.
Some
commands
don’t work
regularly.
Defective keys and
buttons.
Contact the
manufacturer
Failure electronic
control circuit.
The device
works properly,
but there is a
noticeable
drop in the
effectiveness of
the treatment.
Possible head failure.
Contact the
manufacturer
Possible failure of the
device current
generator circuit.
Disposal
The I-TECH UT2, device was designed and engineered to have minimal negative
environmental impact, in consideration of its performance and safety
requirements, following the disposition given by the European Directive
2012/19/EU, regarding the waste of electrical and electronic equipment.
Rigorous standards were followed in order to minimize the amount of waste,
use of toxic materials, noise, non-required radiation and energy consumption.
A deep research on the optimization of machine performances guarantees a
significant consumption’s reduction, in accordance to the saving energy
principles.
This symbol means that the product shall not be disposed as
domestic waste.
