IACER Srl
16
MNPG117-02
•
do not mix connection cables up with earphones or other devices and do
not connect the cable to other equipment;
•
the device is not intended for outdoor use;
•
the device is not intended for use in home environments.
The manufacturer considers himself responsible for the performances,
reliability, safety and security of the device only if:
•
any addition, modification and/or repair are carried out by authorized
personnel;
•
the environmental electrical installation to which I-TECH UT2 is connected
is compliant to the national laws;
•
the instructions for use contained in this manual are strictly followed.
Should any foreign materials penetrate the device contact the retailer or
manufacturer immediately. If dropped down, check that the housing is not
cracked or damaged in any way; if so, contact the retailer or manufacturer.
Should you notice any changes in the device’s performance during treatment,
interrupt the treatment immediately and consult the retailer or manufacturer.
In case of undesired effects, suspend the therapy, stop using the device straight
away and contact your doctor.
The ultrasound therapy controls unit is not designed to prevent the
ingress of water or liquids. Ingress of water of liquids could cause
malfunction of internal components of system and therefore create
risk of injury to the patient/user.
If the patient feels a deep and sharp pain during the treatment, the
intensity must be reduced to a comfortable level
Consult a doctor before using I-TECH UT2 with metallic osteosynthesis
devices.
IF YOU HAVE ANY DOUBTS REGARDING THE DEVICE USE CONSULT
YOUR DOCTOR.
Use of the device
Installation
Remove the device and ala accessories from shipping cartons. Check the device
equipment.
Before the installation and the connection of the device to the mains supply,
check that the voltage and the frequency correspond with the available mains
supply and with the information in this user manual.
Follow the instructions below for a correct installation:
•
connect the power supply cable to the power supply;
•
connect the power supply to the device connector;
