31
6.2
Operation procedure
6.2.1
Driving on the jobsite
1.
Take place on the seat behind the steering wheel. The i-drive® is designed to run only when an
operator is sitting on the seat.
2.
Place the ignition key in the key hole (Figure 23, pos 1).
3.
Turn the ignition key to position "l". The dashboard lights up.
4.
Check the display for the start-up sequence to finish, it will show "Ready" (Figure 23, pos 4).
5.
Check the battery level.
CAUTION
Make sure you have enough capacity left for the job to do. At 20% capacity, alarm level 1
will be activated and shuts down the squeegee and disc brush function.
CAUTION
DO NOT
push the accelerator pedal before start-up sequence is finished.
