•
Vehicle Horn:
Detects car horns.
•
Glass Break:
Detects sound of glass breaking.
•
Other:
Detects other sounds than Gunshot, Yell, Vehicle Horn, Glass Break.
Note
•
In the following cases, sounds to be detected may not be detected.
–
When the duration of Yell, Vehicle Horn or Glass Break is shorter than 1 second
–
When the difference between the sound to be detected and noise is less than 6dB
–
When raindrops directly hit the camera or microphone
•
When multiple sounds of different types occurred at the same time, an alarm notification as triggered
by only one type among these types will be provided.
3.8.8 Configuration of the settings relating to alarm notification
[Notification]
Click the [Notification] tab on the “Alarm” page. (
®
“3.2.1 How to display the setup menu”, “3.2.2 How to
operate the setup menu”)
The settings relating to TCP alarm notification and HTTP alarm notification can be configured in this section.
3.8.8.1 Configure the settings relating to TCP alarm notification
TCP alarm notification
[TCP alarm notification]
Select “On” or “Off” to determine whether or not to provide notification by TCP alarm notification according to
the settings for the “Alarm” and “Diag.” checkboxes of “Destination of notification” below.
–
When an alarm is detected (“Alarm”)
–
When a notification of the remaining capacity of the SD memory card has been provided (“Diag.”)
–
When the SD memory card has become full (“Diag.”)
–
When the SD memory card cannot be recognized (“Diag.”)
–
When an SD memory card write error occurred (“Diag.”)
–
When deviation is detected when registering the initial angle of view, and when the deviation is corrected
(“Diag.”)
–
When the trial period for the extension software ends (“Diag.”)
•
Default:
Off
Note
•
When “On” is selected, notification of the alarm occurrence will be provided to the registered destination
server addresses in order (to IP address 1 first, to IP address 8 last).
[Additional alarm data]
Determine whether or not to send notifications for VMD alarm detection area numbers with the TCP alarm
notification by selecting On/Off.
•
Default:
Off
[Destination port]
Select a destination port for the TCP alarm notification from the following.
•
Available range:
1 - 65535
•
Default:
1818
The following port numbers are unavailable since they are already in use.
118
Operating Instructions
3 Detailed Settings
