14
In order to prevent injury, the product
must be securely mounted to a wall or
ceiling according to Installation Guide.
This equipment is not suitable for use in loca-
tions where children are likely to be present.
Mount the bracket higher than 3.0 m {9.84
feet} from the ground.I
Installation place
<WV-X6533LNS /WV-S6532LNS (Heavy salt
damage resistance) only>
The camera has heavy salt damage resistance
treatment applied, but this does not ensure com-
plete resistance against corrosion. Please pay
attention to the installation location such as in
places where seawater does not splash directly.
Especially when installing this product in coastal
areas and area that are sprayed with snow-melt-
ing agent that are not exposed to rainwater, peri-
odically clean by rinsing to remove adhered salt.
Periodically inspect the camera when installing it
in coastal areas or areas that are sprayed with
snow-melting agent. (Replace parts as necessary.)
Prepare the foundation of the installation site,
installation support, and any other installation set-
ting with heavy salt damage resistance treatment.
<WV-X6533LN /WV-S6532LN >
The product can not be installed in areas by
the sea, the seashore, or where snow-melting
agent is sprayed.
Power supply
This product has no power switch.
When performing electrical work, make sure
the camera can be turned on and off. When an
Ethernet cable or power cable is connected,
the power is turned on. When the product is
supplied, the product will perform panning, tilt-
ing, zooming and focusing.
When cleaning the product, remove the
Ethernet cable or disconnect the power cable
from the main power supply.
Installation area for this product
Select an appropriate place for the installation
area (such as a strong wall or ceiling) in your
particular environment.
• When hanging the camera from a ceiling,
use the WV-Q121B / WV-Q121BS (Heavy
salt damage resistance) (option) ceiling
mount bracket.
• When installing on a wall, use wall mount
bracket WV-Q122A / WV-Q122AS (Heavy
salt damage resistance) (option).
• When pendant-mounting on a ceiling on a
bracket that is custom-made, use the
attachment pipe. <WV-X6533LN /
WV-S6532LN only>
• Make sure that the installation area is
strong enough to hold this product, such
as a concrete ceiling.
• Install the camera in the foundation area of
the architecture or where sufficient strength
is assured.
• Do not mount the product on a plaster
board or a wooden section because they
are too weak. If the product is unavoidably
mounted on such a section, the section
shall be sufficiently reinforced.
When using the camera in combination
with an attachment pipe and attaching to
a locally procured bracket <WV-X6533LN /
WV-S6532LN only>
• Locally procure a M6 eye bolt (stainless steel).
Minimum pull-out strength (per 1 pc.):
1411 N {317 lbf}
• In order to prevent the camera from falling,
procure a bracket that can be attached a
safety wire.
• Connect the M6 eye bolt and locally procured
bracket together with the safety wire.
• Check that the surface that the attachment
pipe and locally procured bracket are to be
attached to can bear the weight of the brack-
et and camera.
i-PRO Co., Ltd. assumes no responsibility for injuries or property damage resulting from
failures arising out of improper installation or operation inconsistent with this documentation.
For information about the installation tasks, refer to the provided Installation Guide.
Precautions for installation
