• Before attempting to connect or install this product, please read these instructions carefully and
save this manual for future use.
• The external appearance and other parts shown in this manual may differ from the actual product
within the scope that will not interfere with normal use due to improvement of the product.
• Read also the installation guide of the camera to be used.
i-PRO Co., Ltd. assumes no responsibility for injures or property damage resulting
from failures arising out of improper installation or operation inconsisntent with this
documentation.
“<Control No.: C****>” used in these documents should be used to search for
information on our technical information website (https://i-pro.com/global/en/
surveillance/training-support/support/technical-information) and will guide you to
the right information.
© i-PRO Co., Ltd. 2023
Cs0223-0
Printed in China
Operating Instructions
Included Installation Instructions
Dome Cover
Model No.
WV-QDC102C
Preface
This product is the clear type dome cover.
The latest information about the supported cameras <Control No.:C0501>.
Specifications
Ambient operating temperature: –30 °C to +50 °C {–22 °F to +122 °F}
Dimensions:
48 mm (W) × 103.5 mm (H) × 47 mm (D)
{1-7/8 inches (W) × 4-1/16 inches (H) × 1-27/32 inches (D)}
Mass.:
Approx. 10
g
{0.02 lbs.}
Finish:
Acrylic resin, Clear
Caution:
• Before attempting to connect or operate this product, please read these instructions carefully.
Precautions
Do not use this product except with suitable cameras.
Failure to observe this may cause a drop resulting in injury
or accidents.
Refer installation work or dome cover replacement to the dealer.
Installation work requires technique and experience. Failure to observe this may cause fire, electric
shock, injury, or damage to the product.
Be sure to consult the dealer.
The screws and bolts must be tightened to the specified torque.
Failure to observe this may cause a drop resulting in injury or accidents.
When using this product, also read the “Precautions” described in the operating
instructions for the camera to be attached.
Standard Accessories
Operating Instructions (this document) ....................................................................................... 1 pc.
Installation
Step 1
Note:
• The front part is secured with
hooks. Push the top of the front
part downward at an angle from
the top of the camera, remove the
hooks in order from the top, and
remove forward.
Front part
Step 2
w
w
q
Step 4
Continued
Top of the front part
Bottom of
the front part
Note:
• Secure the left and right hooks and ribs
at the same time from the top of the
front part to the bottom.
• Make sure that both side covers of the
camera and the attached front part are
completely fixed without gaps.
Step 3
This product
Recommended tightening torque:
0.3 N·m {0.22 lbf·ft}
Note:
• When replacing the dome cover part, be
careful not to touch the surface directly.
• After replacing the dome cover, attach the
protective sheet again.
Step 4
Attach the protective sheet to the dome cover for the installation
work hereafter.
w
q
q
e
r
t
y
Note:
• The front part has 3 fixing hooks and 3 ribs
on each side.
