75
Execute functions for special maintenance and service [Other]
Adjusts the date and time on the camera side to the monitoring system or reboots the monitoring system.
[Synchronize the camera's time with this unit]
Time and date of all the registered cameras will be
synchronized with the clock of this product. The time
and date synchronization will be executed when the
setting is completed after executing on the
confirmation window displayed by clicking the
[Execute] button.
[Synchronize the camera's settings with this unit]
Reconfigure the settings of all the registered cameras
based on the setting information of this product. The
time and date synchronization will be executed when
the setting is completed after executing on the
confirmation window displayed by clicking the
[Execute] button.
Important:
• Since this setting will change the settings of all
cameras, please take an extra caution in case that
the settings of each camera are customized
individually.
[Acquire the SD backup data from camera]
Starts to acquire the image (SD memory data)
recorded on the SD memory card of the camera in
which the SD memory backup is set.
[Reboot this product]
Reboots the recorder.
[Boot this product in the board replacement mode.]
Used to replace the board.
Note:
• The board replacement mode is used during
maintenance. Do not use it in ordinary operation.
• Contact your dealer for the board replacement.
[Clear the maximum temperature record information.]
Clears the highest temperature record information.
[Reset the maximum PoE total power supply
information]
Reset the maximum PoE total power supply
information of this product.
[Measure the network transmission/reception speed]
Used to measure the amount of network traffic
transmitted from the recorder. Click the [Execute]
button and execute from the confirmation window
displayed. After configuration is completed,
measuring starts.
The result of measurement will be displayed after
measurement finishes.
Note:
• Measurement is made from about 8 seconds after
setting is done and will continue measuring for 10
seconds.
• Status display area of operation screen will
display " Measuring" while measuring.
• The result of measurement is the sum of all
network ports.
• The result of measurement is only for reference. It
may differ depending on the network environment.
[Terminal output test]
Outputs a signal from ALARM/CONTROL connector
on the rear panel of the recorder.
Terminal: Selects the terminal at which to output the
signal.
Test output duration: Select the duration over which
the signal is output as 2 seconds, 5 seconds, or
10 seconds.
The signal will be output from the selected terminal
when executed from the confirmation screen that is
displayed by clicking [Execute] button.
[Setup via recorder's main monitor]
