Device Overview
How to wear your Q-66HR?
User Manual
Q-66HR
Q-Band
EN
Wear Q-66HR on your wrist
1
2
3
4
Charge your Q-66HR
Fasten Q-66HR with clasp
Change the wristband
Put on the wristband with the screen facing up and the band
wrapped around your wrist. Align the clasp along the band to
find the holes where best fit the clasps.
Squeeze both clasps into the holes on the wristband until you
hear a click, indicating the band is securely fastened.
Spread open both bands with the screen facing up, and press down the screen
with your thumb until the core comes off the wristband.
Insert the core with screen facing up into the notch from below the wristband.
Make sure the two tenons on each side of the core are securely fixed into the
corresponding slots in the bands.
Button up the clasp on the side of the band with 2 holes. Please note that the
charging contact should be near the clasp.
Important Notice:
Failure to follow the instructions above might cause damage to the device.
1.
2.
3.
1
1
2
3
2
Wristband
Clasp
Core
Touch Button
Metallic contact for charging
Optical Sensor
To charge your Q-66HR, place it in the charging box at the
other end of the USB cable. Close the box afterwards, and
make sure the Q-66HR is securely covered. Plug the USB
connector to either a PC or power adapter to start charging.
