I-Bike CITY EASY URBAN, Instructions Manual

Page: 42 / 76

42/76
Procedure for charging
Please charge the bike battery according to the following procedure:
7.1. The battery can be charged by the AC, the switch is not necessary to be turned on.
7.2. Insert the charger output plug into the battery securely and then, plug the main
cable of the charger into a reachable AC outlet;
7.3. When charging, the LED on the charger will become red, showing the charging is on.
When it becomes green, you can finish charging the battery.
7.4. To finish charging, you must disconnect the charger input plug first from the AC
outlet, and after that, disconnect the charger output plug from the battery pack.
Finally, close the cover on the charging socket of the battery pack and check the
socket, is covered.
8. Using and maintaining the electric hub motor
8.1. Our intelligent e-bikes are programmed to start with the electric assistance after
rotation of the chain wheel.
8.2. Do not use the bike in flood waters or thunderstorm. Do not immerse the electric
parts in water. Otherwise, the electric components may be damaged.
8.3. Avoid any impact towards the hub motor, otherwise, the casting alloy aluminum
cover and body may break.
8.4. Make regular checks on the screws on both sides of the hub motor; fasten them even
if they are just a little bit loose.
8.5. It is necessary to check the cable connection to the motor.
9. Maintaining the controller
For our electric bikes the controller is usually equipped inside the battery pack holder.
It is very important to take care of this electronic component, according to the following
guideline:
9.1. Pay attention to protect from ingress of water and immersion in water, which may
damage the controller.
Note: If you think water may have got into the control box, please switch off the power
immediately and pedal without electric assistance. You can pedal with electric assistance
as soon as the controller has dried out.
9.2. Pay attention to protect from any strong shaking and punching, which may damage
this controller
9.3. The controller should be used in normal working temperature range from -15°C to
+40°C
WARNING: Do not open the controller box. Any attempt to open the con-
troller box, modify or adjust the controller will void the warranty. Please
ask your local dealer or authorized service specialist to repair your bike.