N700E INSTRUCTION MANUAL
2-21
2.2 Programming N700E VFD
In order to operate N700E VFD as desired, corresponding parameters must be programmed properly
with specific setting values. Parameters are set using keys on the keypad. Described each key function
and navigating parameters using these keys. Illustrated is how to change parameters and
corresponding values.
2.2.1 Keypad Overview
Programming Parameters is done by keypad. N700E Keypad has four major parts:
Display
Functional Keys
Potentiometer
LEDs for status indicator
Its view and description are illustrated in Figure 2-13
and Table 2-14 respectively.
Figure 2-13: N700E Keypad View
Key Pad
Description
KEY
STOP
RESET
Stop / Reset
Function
FUNC
Run
UP Arrow
Down Arrow
Store
RUN
STR
Potentiometer
Stop the motor or reset the faults
Selection of parameter and parameter value
To run VFD. Key is active when its LED is ON
Increment the parameter or increase the parameter value
Decrement the parameter or decrease the parameter value
Stores the new parameter value to memory
Set the VFD output frequency setpoint. Active when its LED is ON
LED
Display
Power
RUN
A
Hz
PRG
Displays Frequency, Motor Current, Motor Speed, Fault History, and
parameter values
Indicates internal power circuitry is properly operating.
Indicates output frequency is greater than 0 Hz.
Parameter on Display is in units of Amperes
Parameter on Display is in units of Herz
Indicates in program mode. Parameter value can be modified.
Table 2-14: Keypad Description